Description below as usual...have fun!
Strength
WoD
15 minutes - AMRAP
- 10 deadlifts
- 10 burpees over bar
- 10 bent over rows
Exercises
- Deadlift
Use the same barbell that you were using for the good mornings. Place the barbell on the floor pretty much right in front of your feet (with a full Olympic bar, you'd put your feet right underneath the bar). Stand with your feet about shoulder-width part, and bend your knees slightly (about 20 degrees) to reach down to grab the barbell. You want your hands on the outside of your legs/knees, and you want to start with the barbell to be high enough off the ground to be about halfway up your shin (this is about the same height as an Olympic bar resting on the ground with 45lb plates on it). Keeping your head up and your chest facing forward, lift your torso a few inches until the barbell almost hit your knees. Your arms shouldn't bend at the elbows, you're just lifting your upper body with the weight conveniently attached to the upper body. Also, the weight should move in a straight vertical line, with no horizontal motion. It can help to think about it as if you're trying to skin your shins with the weight.
Once the barbell is at about your knees, pop your hips forward to generate some more momentum. At the same time, contract your shoulder blades towards each other. This will naturally pull the weight up even more (again, in a straight line). You should be standing straight up with your chest out at the top of the movement. Even though it looks like you're pulling the weight up using your biceps, you should try to avoid pulling up with your arms. That actually decreases the amount of weight you can lift in the long run, and it's bad form. - Burpee over bar
It sounds complicated, but this is only a slight variation on a traditional burpee. Before you start, put the bar down so that it runs parallel to the way your body is oriented for the push up portion of the burpee. You're going to jump sideways over it eventually. You can rest the actual plate part of the barbell on a riser to keep it from rolling.
With that little bit of pre-work out of the way, it's still a 5 step motion: 1) squat down & touch the ground, 2) kick your legs out into a push-up position, 3) do a push up, 4) jump back to the squatting position, 5) come up from squatting and jump sideways over the bar. You're going to end up jumping back and forth over the bar (if the first jump is to your left, you'll jump to the right for your next rep). With a weight lifting bar, this forces you to jump at least a few inches off the ground.
Once it starts to feel normal to do this motion, you can start to make it a smoother motion by essentially dropping down into a push up position, rather than squatting and then kicking out your feet. It requires a little bit less energy, but it also requires more coordination and muscle memory.
Scale down: Step sideways over the bar instead of jumping. This takes less energy, but still makes you do the work. - Bent over row
You'll need a barbell for this; I usually see between 45lbs and 90lbs.
To begin with, put it down in front of you. Start with your feet a little bit more than shoulder-width apart, and bend your knees to reach down for the barbell. Grab the barbell with your hands on the outside of your legs/knees, so that your hands are slightly farther apart than your feet. From that position, stand straight up so that you have the barbell resting near your thighs (if you know what a deadlift is, you basically need to do one of those).
From that position, bend your knees slightly and bend forward until your back is at about a 30 degree angle. Your back still needs to be as flat (like a table top) as you can manage. Squeeze your shoulder blades together before you start, and then pull the barbell straight up to your chest while keeping your back stationary. Bring it back down to the bottom in a fluid motion to finish the rep. You want to bring the weight up and down from this position until you've finished all of your reps.
No comments:
Post a Comment