I missed classes this week, but I asked for the WODs. This one is about par for the course, it has a combination of several muscle groups. It's not going to demand tons of reps of any one muscle, but you will be going at a good clip. That, and there are burpees thrown in.
For the strength portion, you get one attempt to do as many push ups as you can with some weight thrown on top of you. There's no time limit, but if you stop mid-rep, you're done. It's easiest to do this with a plates on your back, but you can use any kind of weight that won't roll off your back. If you're a guy, you have to put 45lbs on your back. For the women, it's 25lbs.
The trickiest part of this is just getting the weight onto or off of your back. The simplest way to do this is to kneel down on all fours, and slide the weight onto your lower back. You actually want the weight to be roughly on top of your shoulder blades, so reach back with both hands to slide the weight up towards your upper back. Of course, if you have a partner, they can simply place the weight on your back once you're in push up position. You want your entire body straight/rigid, without a bend at the waist, and you want to maintain this position the whole time. If you start dropping your waist, you're not doing it right. Bring your chest to the ground for every single rep, and when you come up, make sure your arms are fully extended. To get the weight off of your back, bring your knees in to a kneeling position, and reach behind you with both hands to grab the weight. That should give you enough control to then safely remove the weight. The starting position for this is with the barbell around mid-thigh in front of you, with a slight bend to your waist (this position is considered a "high hang" so that's where the name comes from). Obviously, though, you have to get the barbell there from the ground somehow. The safest way to do this is actually to deadlift the barbell. In essence, keep your chest up, squat down, and then lift the barbell from the ground using your legs (not your back). From that position, shrug your shoulders. I know it sounds silly, but it should be an *aggressive* shrug. You really want to build some momentum in that motion. Remember, though, keep your arms locked as you're doing this, or you'll end up doing more of a curl. If you need to make sure you've got it down, practice just that part of it a few times. The next step, starting from the shrugged shoulder position, is to quickly bring the weight up to about chest level and bend your knees a tiny bit at the same time. If you were to watch the path the weight travels, it should be completely vertical. If the weight travels in an arc away from your body, you're doing it wrong. Your hands don't lift the weight as much as they adjust themselves to hold the weight differently. At the end of this motion, you should have your palms facing away from your body, as if you were "racking" the barbell near your chest/clavicle. You can almost think of it as letting go of the weight in midair, and positioning your body so that you can receive the weight with the weight at your chest. Don't actually let go, that can be all sorts of bad. However, you'll find that because there's so much momentum and you're trying to "catch" the weight with your knees slightly bent, you're pretty much jumping into it. At the same time, your hands will suddenly shoot up to hold the weight at your chest. As always, keep a good lumbar curve. You don't want to bend over as you do this. If you do it wrong repeatedly or with a heavy enough weight, your lower back will pay for it. You can practice this one step at a time until the motion starts to feel more natural. Lastly, just stand up straight while holding the weight at your chest. Once you've stood all the way up, you can drop the weight back down to thigh-level to start over. That's the end of a single rep. Now all that's left is to put it all together in a smooth motion. It sounds complicated, but this is only a slight variation on a traditional burpee. Before you start, put the bar down so that it runs parallel to the way your body is oriented for the push up portion of the burpee. You're going to jump sideways over it eventually. You can rest the actual plate part of the barbell on a riser to keep it from rolling. With that little bit of pre-work out of the way, it's still a 5 step motion: 1) squat down & touch the ground, 2) kick your legs out into a push-up position, 3) do a push up, 4) jump back to the squatting position, 5) come up from squatting and jump sideways over the bar. You're going to end up jumping back and forth over the bar (if the first jump is to your left, you'll jump to the right for your next rep). With a weight lifting bar, this forces you to jump at least a few inches off the ground. Once it starts to feel normal to do this motion, you can start to make it a smoother motion by essentially dropping down into a push up position, rather than squatting and then kicking out your feet. It requires a little bit less energy, but it also requires more coordination and muscle memory. Scale down: Step sideways over the bar instead of jumping. This takes less energy, but still makes you do the work. Lie on your back, putting our hands parallel to the ground "above" your head (if you were standing, they’d be directly over your head). Lift your legs off the ground and bring your torso up at the same time to touch your toes. In essence, your body makes a "V" shape. Go back to lying on your back to finish the rep. Be careful about slamming your legs into the ground when you finish the rep, that can hurt your lower back. Some people call these "jack knives," if that helps at all. Scale down: Bend your knees as your bring your lower body up. You only have to touch your knees this way
Strength
WoD
As Many Rounds As Possible (in 15 minutest) of:
Exercises
As always, have fun with it.
No comments:
Post a Comment