This one was another one that I had to miss, but it was a relatively quick one (Thursdays tend to be because there is a class right afterward). Incidentally, it was also a "Pick Your Poison" day, because there was a ground to overhead rep. Basically, you get to pick how to get the barbell overhead. I always include the more common options, but it's completely up to you how to do the rep. You just have to do it SAFELY. If you can't do it safely that way, pick a different option.
For the initial "buy in" part, it was a team effort. If anyone dropped, everyone had to stop and the clock stopped. If you're doing this on your own, just stop the clock if you have to come down. Once you're ready to get back into the plank, start the clock again.
As far as safety goes, the ground to overhead is the biggest thing to watch for. You're throwing a barbell around and lifting it over your head, so do not get sloppy about your form. That's just tempting fate. The box jumps can hurt your legs (shins, usually) if you slip up, so watch where you're jumping. The lunges shouldn't be too bad, but you can put extra strain on your knees if you're sloppy. So, don't get sloppy.
Buy In
- 5 minutes of a plank
WoD
As Many Rounds As Possible (in 12 minutes) of:
- 5 ground to overhead
Possible Options: - 10 box jumps
- 15 dumbbell lunges (left/right = 1)
Exercises
- Plank
From a push up position, lower yourself so that your weight is resting on your forearms. Keep yourself there without moving up or down for a total of five minutes. If you have to stop at some point, you can, but then the clock stops. You will want to make sure you're in a plank position for the full time.
- Snatch
Grab a barbell, and weight it as heavily as you can. Remember that you're going to have to do a lot of reps with this weight, so find something that you can handle for that many reps. It's pretty common for people to use between 45 and 90lbs.
Stand with your legs shoulder-width apart, with the weight on the ground in front of you. Squat down and reach down to grab the bar with a very wide grip; it should be about two shoulder-widths apart. Whatever you do, don't bend over to grab the barbell, since that's a bad habit to get into (your back will not like you). Stand and bring the barbell straight up, aggressively shrugging your shoulders (this helps generate momentum). You want to pull it straight up and jerk your hips forward. The momentum from your lower body will actually help drive the weight up, so that you're not actually lifting the weight with nothing but your arms.
Once the weight comes to about chest level, squat down and raise the barbell so that your arms are above your head. Your arms will make a Y shape with your upper body. Again, you want the weight to travel in a straight, vertical line. Since you're trying to drive so much momentum, you're actually going to stomp hard/jump a tiny bit to get into the squatting position. Keep your weight back on your heels throughout, so that you are as stable as possible with the weight above your head.
Also remember that you want a good lumbar curve at the bottom of that squat. Just because you have weight in your hands, you don't get to cheat on your form (arguably, it's far more important then). Once you're down at the bottom of your squat with the weight over your head, stand up. Remember to keep your arms locked the whole time, since the weight is above your head. It's safe to bring the weight back down to finish the rep AFTER you have completely stopped moving your feet and you are in a standing position.
- Clean & Jerk
To begin with, put the weight on the ground in front of you. Squat down to grab the weights, but remember to face forward and keep your chest facing forward. Squeeze your shoulder blades tight to reduce the strain on your lower back. Stand up, but as you do so, shrug your shoulders aggressively. I know it sounds silly, but it should be an *aggressive* shrug. You really want to build some momentum in that motion. However, keep your arms locked as you're doing this, or you'll end up doing more of a curl. If you need to make sure you've got it down, practice just that part of it a few times.
The next step, from the shrugged shoulder position, is to quickly bring the weight up to about chest level and do a quick hop at the same time. If you were to watch the path the weight travels, it should be as close to your body as possible, and as close to completely vertical as possible. If the weight travels in an arc away from your body, you're doing it wrong. Your hands don't lift the weight as much as they adjust themselves to hold the weight differently. At the end of this motion, you should have your palms facing away from your body, as if you were "racking" the weight near your chest/clavicle.
You can almost think of it as letting go of the weight in midair, and positioning your body underneath the weight so that you end up with your knees slightly bent and the weight at your chest. Don't actually let go of the weight, that can be all sorts of bad. However, you'll find that because it's a quick hop, you're pretty much jumping into it. At the same time, your hands will suddenly shoot up to hold the weight at your chest.
As always, keep a good lumbar curve. You don't want to bend over as you do this. If you do it wrong repeatedly or with a heavy enough weight, your lower back will pay for it. Again, practice just the squat motion a few times so that it feels natural. That's the "clean" part of this.
The last part, the "jerk" in the name, involves violently shoving the barbell directly over your head. Make sure that you're in a quarter squat position, then very aggressively press the weights directly over your shoulders. In fact, your momentum will cause you to do a slight hop while your hands go upwards. At the top of the rep, your arms should be completely locked out, and you should stand tall. Because this lets you use your legs to drive the momentum and the power, this should feel easier than a strict shoulder press.
To finish the rep, you have to lower the weight to the ground safely (we're not allowed to just drop weights). From the locked out position at the very top, bring the weight straight back down to the racked position (resting on your shoulders/clavicle, palms facing away from you, elbows as high up as you can). From there, lower the weight to your thighs using your arms. Lastly, squat down to put the weight on the ground. You'll need to keep your chest facing forward the whole time; don't bend forward at any point. All of that is one rep. If you need to, practice the motion until it starts to feel natural; form is really important here.
- Deadlift
Place a barbell on the floor pretty much right in front of your feet (with a full Olympic bar, you'd put your feet right underneath the bar). Stand with your feet about shoulder-width apart, and bend your knees slightly (about 20 degrees) to reach down to grab the barbell. You want your hands on the outside of your legs/knees, and you want to start with the barbell to be high enough off the ground to be about halfway up your shin (this is about the same height as an Olympic bar resting on the ground with 45lb plates on it).
Keeping your head up and your chest facing forward, lift your torso a few inches until the barbell almost hits your knees. Your arms shouldn't bend at the elbows, you're just lifting your upper body with the weight conveniently attached to the upper body. Also, the weight should move in a straight vertical line, with no horizontal motion. It can help to think about it as if you're trying to skin your shins with the weight.
Once the barbell is at about your knees, pop your hips forward to generate some more momentum. At the same time, contract your shoulder blades towards each other. This will naturally pull the weight up even more (again, in a straight line). You should be standing straight up with your chest out at the top of the movement. Even though it looks like you're pulling the weight up using your biceps, you should try to avoid pulling up with your arms. That actually decreases the amount of weight you can lift in the long run, and it's bad form.
- Hang Power Clean
You'll need a barbell for this, so weigh it with whatever feels comfortable; most of the time, I see anywhere between 45lbs and 90lbs.
The starting position for this is with the barbell around mid-thigh in front of you, with a slight bend to your waist (this position is considered a "high hang" so that's where the name comes from). Obviously, though, you have to get the barbell there from the ground somehow. The safest way to do this is actually to deadlift the barbell. In essence, keep your chest up, bend down, and then lift the barbell from the ground using your legs (not your back).
From that position, shrug your shoulders. I know it sounds silly, but it should be an *aggressive* shrug. You really want to build some momentum in that motion. Remember, though, keep your arms locked as you're doing this, or you'll end up doing more of a curl. If you need to make sure you've got it down, practice just that part of it a few times.
The next step, starting from the shrugged shoulder position, is to quickly bring the weight up to about chest level and bend your knees a tiny bit at the same time. If you were to watch the path the weight travels, it should be completely vertical. If the weight travels in an arc away from your body, you're doing it wrong. Your hands don't lift the weight as much as they adjust themselves to hold the weight differently. At the end of this motion, you should have your palms facing away from your body, as if you were "racking" the barbell near your chest/clavicle. You can almost think of it as letting go of the weight in midair, and positioning your body so that you can receive the weight with the weight at your chest. Don't actually let go, that can be all sorts of bad.
However, you'll find that because there's so much momentum and you're trying to "catch" the weight with your knees slightly bent, you're pretty much jumping into it. At the same time, your hands will suddenly shoot up to hold the weight at your chest. As always, keep a good lumbar curve. You don't want to bend over as you do this. If you do it wrong repeatedly or with a heavy enough weight, your lower back will pay for it. You can practice this one step at a time until the motion starts to feel more natural.
Lastly, just stand up straight while holding the weight at your chest. Once you've stood all the way up, you can drop the weight back down to thigh-level to start over. That's the end of a single rep. Now all that's left is to put it all together in a smooth motion.
- Push Press
To start, hold the barbell slightly below shoulder level with both your palms facing away from your body so that you can see both palms in a mirror. You want the weights "racked" against your chest, with your elbows farther forward than the bar. You don't need to bring them all the way up like you do with a front squat, but you do want your forearms vertical and supporting the bar from underneath.
Do a quarter squat, and come up as explosively as you can. In reality, you'll end up end up hopping up a tiny bit because you're generating so much momentum/power from your legs. That's okay, but be absolutely sure that you're in control as you do this. You really don't want to trip or fall while holding a barbell. As you come up, press the barbell directly over your head. Remember, your legs should be driving the power in this motion, not your shoulders or arms. At the top of your motion, you want your arms to be fully extended and your legs completely straightened out. Also, bring your head forward a bit so that your arms, spine, and head are all aligned along the same vertical plane.
One last cue is to make sure you move the weight directly up & down; if you start moving the horizontally, you'll put extra stress on your shoulders. If your elbows flare out horizontally, that's also going to make it difficult to press straight up & down. Finish your rep by bringing the weight back to beginning/racked position.
- Box Jump
You'll need to set up a platform with risers; most people use at least 2, but I've seen up to 5 on occasion. Before you even start the WoD, stomp on it really hard. You want to make sure it'll support your weight & won't move around when you jump on it. Just in case, look down at the platform when you jump. If it does move around at all, keeping your eyes on it should help prevent injury.
When you do jump on it, you want to make sure that you stand tall once you're on the platform. If you stay hunched over the whole time, you're not getting the full effect of the exercise. One way to think about this is that you want your hips to "open up" on both the jump up and the jump down; all that really means is that your hips should be pushed forward once you're standing on top of the box.
Scale down: Step up to the box, and then step down instead of jumping on the platform. If you do step, make sure you alternate which leg comes down off of the platform first.
- Dumbbell Lunges
Hold the weights at your side, one on each side. From a standing position, bring one leg forward in a straight line, and then bend your knees so that both your knees are bent at 90 degrees. Make sure that your front foot is firmly planted on the ground; the heel of your foot should be touching the ground. The back knee should be close to the ground, and your front knee should be directly over your front foot (otherwise you're putting undue stress on your knees).
One cue that can help some folks is to treat your lunge like you're going straight up and down with your back leg. Your knees don't quite have to touch the ground (you might get burns/scrapes that way), but come as close as you can to that.
This time around, you have to bring both legs forward to get credit for a single rep (we call this "right/left = 1" for short).
No comments:
Post a Comment